How to Operate a Can Sealer?

The sealing of the can body and lid must be rolled by the first and second rollers. When the can is sealed, the correct position of the sealing roller should be adjusted. The adjustment bolts on the roller brackets installed on the tray can be adjusted according to the diameter of the sealing tank. (See Figure 2) Just loosen the locking bolt first, adjust the position of the roller, and then lock it.

Sealing the cans needs to be replaced with the corresponding pressure head of the can lid.

Sealing adjustment: because this machine is a four-roller sealing can, that is, two rollers seal the head and two rollers seal two. When adjusting, first adjust the second roller, and then adjust the first roller. Note that the radial dimensions of the first two rollers should be the same until the product is properly sealed, and then exit with the following mark. Use the same method to adjust the second roller. After adjustment, restore the position of the first track roller and try sealing again.

Adjust the height of the tank: remove the front cover at the bottom of the fuselage, loosen the fixing nails, and then turn the screw rod to obtain the required height, then tighten the screws and install the cover.

Clutch height adjustment: you can open the cover on the body, loosen and tighten the nut, turn the left and right threaded adjustment nut 23 and tubular adjustment nut 24 to carry out, after adjustment, tighten the nut.

Do not turn on the motor during adjustment, only turn the tray by hand. After the adjustment is completed, all the screws and nuts are tightened, and the manual working cycle is correct, then the motor can be started for testing.